Quietline Series

For manual transmission cub cadets. May also work on others. 5/8" ID with 1/4 holes for shear pins (not included) Replaces Cub Cadet PN# IH-394036-...

Need a way to add some stability to the rear axle of your tractor? Introducing the race brace. It uses the 2 holes in the axle tube and nests up ag...

Mount for the front of your wideframe and 82 series tractors to mount a generator on. Very similar to the Pincor ones. Will hold multiple size gene...

Reproduction of the Cub Cadet Hydraulic Lift Pump Mounting Pin. PN# CC-23-051

Reproduction of the Cub Cadet Hydraulic Lift Pump Mounting Bracket. PN# CC-23-050

Stainless Steel Exhaust Tip for Diesels. This is just for the extended tip. Muffler or rest of tractor not included. Approx. 12" long. PN# CC-31-101

Creeper Drive Shift Yoke PN/ IH-385042-R1 USE 703-0409 IH 385042 R1 Unpainted PN# CC-96-001

Clutch operating yoke bracket NF PN/ IH-384656-R1 USE IH-384656-R2 IH 384656 R1 Unpainted PN# CC-96-002

Category 0 - Top Link Pin - Bent PN# CC-36-004

5/8" x 1 1/2" Headed Pin PN# CC-36-007

5/8" x 1" Headed Pin PN# CC-36-006

1/4" Lynch Pins PN# CC-03-005

5/8" Pin for the top link. PN# CC-36-011

If you have a 3 point and want to hold it in the up position while you use the mower deck, you can use this adjustable dog-bone link to hold the lo...

Manufactured adjustable 3 point upper link bracket. If you have an original Cub Cadet 3 point lift, and are missing this bracket, now you can get a...

If you have a category 0 3 point drawbar (CC-98-002) then these drawbar locks are a must. Keeps the drawbar from rotating if using a ball hitch. Cl...

Fits category 0 three point hitches. The ends are 5/8" diameter with 1/4" holes for retainer pins. The (7) holes in the bar are 3/4" for ball hitch...

This is the upper 3rd link for the Super Garden Tractors that have the factory 3 point setup on them. The top link uses a 1/2" dia pin instead of t...

Connects the 3rd link to your implement. Completely adjustable from 10" to 15". 5/8" holes. Comes with hole in the middle and rod to make it a T-Ha...

Replacement ferrule for Cub Cadet 3 point lifts. 5/8" Threaded hole, 5/8" Stud, 1/8" Pin Hole. Similar to Cub Cadet #711-3122

Just like the original ones, (CC-34-013) but 1.5" longer. Allows you to run equipment that is lower to the ground.

Connects the 3 point rock shaft arms to the lift arms. 5/8" - Cat. 0 ball sockets, 5/8 threaded shaft. Sold each. Similar to Cub Cadet #703-0814

Replace your worn-out step pads with these Aluminum Step Pads. Made out of .080" Thick Brite-Tread Aluminum.

Fits Quieline series. 1250 1450 1650. Headlights, Gromets or Emblem not included. UNPAINTED