Products

Narrow Frame lift bracket blocks. Comes with hardware.

We offer 2 different materials - AR Steel and Stainless Steel and Thicker (.179") than OEM to suite your needs. Laser cut to Original OEM Specs. Un...

These brackets were used for putting an "Original" timed deck on a 70/100 Unpainted. PN# CC-96-065

For mounting the power steering sector into 82 series tractors. Very hard to find. Unpainted. PN# CC-30-001

We have had requests for a larger center dual wheel spacer that will clear over some brands. The larger center is 3" clear inside diameter. These a...

For the Wide Frame and Narrow Frame Front PTO's. Made to exact specs as the original, but out of .062" thick stainless steel.

Fits the 70/100 and more. PTO Engagement Lever. Made from Stainless Steel, polish it up for that chrome look. PN# CC-38-003

Fits the 70/100 and more. Holds the PTO lever in place. UNPAINTED. PN# CC-38-002

Replacement Lifting Bracket for the Push Blades. Made from 1/2" HR Steel. IH-57217-C1 Unpainted. PN# CC-69-012

Replacement spring for the trip push blades. Also fits spring assists. Same length as OEM. Comes with eye bolt and nut. Similar to Cub Cadet #IH-PO...

An aftermarket muffler shroud that replaces the stock muffler boxes that usually break due to vibration. Simplified design. Heavier sheetmetal used...

Fits Quieline series. 1250 1450 1650. Headlights, Gromets or Emblem not included. UNPAINTED

Fits Quieline series. 1250 1450 1650. Headlights, Gromets or Emblem not included. Unpainted.

Solid motor mounts that go between the motor plates and frame. Grade 8 hardware and Nylock nuts. PN# CC-96-503

A new style differential cover that allows you to fill your rear end without having to use the fill tube. Bottom of the fill hole is matched to the...

This Replacement Style Sleeve Hitch Bracket is an exact reproduction of the original used on Cub Cadets, maintaining stock length and width for a p...

Reproduction hood for the Cub Cadet "Original". Part is an identical match. Original hoods were made out of .036" steel and we made these out of .0...

A dual edged push blade. One side has serrated teeth and the other has the smooth edge like the OEM blade. It is made out of AR400. AR stands for "...

Reproduction of the original unit. Unpainted.

Need a way to add some stability to the rear axle of your tractor? Introducing the race brace. It uses the 2 holes in the axle tube and nests up ag...

This is the upper 3rd link for the Super Garden Tractors that have the factory 3 point setup on them. The top link uses a 1/2" dia pin instead of t...