Part Number: CC-03-001M
This is the same kit as CC-03-001 except the main 3 point plate is re-designed to give you more lifting configurations. The lift arms have holes moved inwards and out to give you more or less lift height and power. The kit is designed to work off of the single deck lift system. You can leave your deck on and lock it in the up position while using your 3 point accessories. Complete kit. Retrofit to fit more tractors than the original 190-389 kit by Cub Cadet. Ships Unpainted.
Some major improvements were made to this kit:
1. The holes in the lift arms are moved in 1", stock position (middle hole) and outward 1"
This gives you the following lifting configurations:
Inner hole - More lifting capacity, less lift height, more control - 1.75" less travel than stock, 35% more lifting power
Stock hole - same power and speed as stock - base line lifting capacity
Outer hole - Less lifting capacity, More lifting height, Less control - 2" more travel than stock
2. Bottom add on tabs to the rear axle tubes have been incorporated in.
3. Extra drag arm pin holes added for more customization.
4. Hydraulic port holes moved over closer to the frame so that the lines can run right next to the frame the whole length of the tractor
Pictures are shown on a 982. Will not work on tractors with PTO. Receiver hitch sold separately.
May fit others, but not tested yet. Part is raw steel, UNPAINTED.
Buyer must make sure this will fit his tractor before ordering.